Showing: 1-4 of 4  
Articles
 
document I have a lot of incoming connections on port 3128 from all over the internet, and now my bandwidth is full. What did I do wrong?
You have most probably enabled the HTTP Proxy on one of your external interfaces. By external interfaces I mean interfaces that have a routable IP assigned to them (as primary IP or as an alias). You must configure the HTTP Proxy only for your internal/private networks. When activating the...
22 May, 2009 Views: 118 Comments: 0
document Writing a flash card using the sw-disk tool fails. How do I make it work?
Most modern Linux distributions come with the automounter enabled. This is normally used to automatically mount newly connected USB stick drives or inserted CD-ROMs. The problem is that this behavior interferes with Syneto's sw-disk and it will fail. Solution: Disable automount on your...
27 May, 2009 Views: 119 Comments: 0
document I need to erase all data from disk in an installed UTM. How do I do that?
Some times you may want to clean up an UTM disk. The reasons include: Moving an UTM from a customer to another Installing new UTM with a disk that has unwanted logs Recovering from a broken filesystem Installing a disk that already has a reiserfs partition as hdX2 To do this,...
27 May, 2009 Views: 102 Comments: 0
document I configured my VPN connection but tunnel status is DOWN (yellow). Why is it not connecting?
 The tunnel with status DOWN in yellow means ISAKMP SA established, but no IPSec SA established. It means that the encrypted communication is established but the network parameters of the tunnel cannot be set. This problem is most likely related to mismatching network configurations for one...
04 Jun, 2009 Views: 134 Comments: 0

(c) Copyright 2008-2010 S.C. Syneto S.R.L. Romania